Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Trusted Door Installation for Port St. Lucie Homeowners
Door installation in Port St. Lucie means dealing with humidity, salt air, and afternoon thunderstorms that punish a poorly set frame. We have been replacing entry doors, French doors, and storm doors in this community for years, and the call we get most often starts the same way: a door that stuck last summer now will not latch at all, or a frame that has gone soft at the bottom from irrigation splash-back. TruePane Windows & Doors is owned by Dale Kessler, a second-generation glazier, and our crews install doors the way a door should be set: square, leveled, shimmed, and sealed so it stays true through every season. Call (772) 362-3326 and a live person answers. That is not a call center. It is us.
What Our Door Installation Service Includes
Every door we hang in Port St. Lucie gets the same treatment, whether it costs nine hundred dollars or nine thousand. We measure the opening twice, check the floor for level, set the frame with shims rather than hoping the rough opening was framed right, and register both manufacturer warranty layers before the truck leaves your driveway. That last part is The Keystone Standard, and it is what separates a door that works for five years from one that binds every July.
Entry & Swing Doors
An entry door in Port St. Lucie takes a beating from sun on the west side of the house and wind-driven rain on the east. We install fiberglass, steel, and wood Entry & Swing Doors with full perimeter weatherstripping and sill pans that keep water moving away from the threshold. If your current door drags against the jamb or lets daylight show around the edges, the frame has likely moved and a new slab alone will not fix it. We set new pre-hung units so the reveal is even on all three sides, which is the difference between a door that closes with a click and one you have to shoulder.

Double & French Doors
Double doors fail twice as often as single doors because two slabs have to meet perfectly in the middle while the frame stays square. In Port St. Lucie, where slab foundations settle and humidity swells wood, we see French doors that lock fine in January and bind by August. TruePane installs Double & French Doors with adjustable astragals and multi-point locking hardware, then checks the alignment with both doors closed, latched, and deadbolted. A French door should feel like one unit when it is locked, not two doors arguing with each other.

Bifold & Folding Doors
Bifold & Folding Doors, including patio doors that stack against the wall, demand a level track and a perfectly straight header. We have torn out folding doors that were installed on a floor that pitched a half inch over eight feet, which is why the panels jammed halfway open. Our crews level the track, shim the frame, and adjust each panel carrier so the whole stack folds with one hand. If you want an opening that connects your living room to the lanai, this is the system that does it, but only if the track is right.

Pivot Doors
A pivot door hangs on a top and bottom hinge rather than jamb hinges, which lets you run a much taller and wider slab than a conventional entry. These are heavier doors, often eight feet tall, and the pivot point has to be set exactly or the door will drift on its own. We set pivot hardware into reinforced framing, check the reveal at the top and bottom, and balance the door so it stays where you leave it. A pivot door should feel weightless when it moves and solid when it stops.

Storm Doors
A storm door in Port St. Lucie is not just a second layer against wind; it is also the screen door that lets a cross-breeze through in January when the air is dry enough to open the house. We install full-view and retractable-screen storm doors with closers adjusted for the right swing speed so the door does not slam in the afternoon breeze off the Intracoastal. The most common complaint we hear is a storm door that will not latch because the original installer set it over an out-of-square entry frame. We square the storm door to itself, not to the house, and it closes right every time.

Arched & Custom Doors
Arched & Custom Doors and custom-shaped entries cannot be ordered out of a catalog and forced into a rectangular opening. We template the actual opening, order the unit to match, and fabricate the trim and sill on site. In St. Lucie West and newer neighborhoods, we see arched entryways that previous contractors filled with a rectangular door and a sheet of plywood above it. That is a patch, not an installation. We build the opening to match the door, or build the door to match the opening, whichever the house needs.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Door Installation
We are an authorized installer for more than a dozen manufacturer lines, including, PGT, CGI, and ES Windows. That authorization matters because it means we have access to the factory installation specifications, the proper mounting hardware, and the warranty registration channels. A door installed by an unauthorized contractor can void the manufacturer’s warranty even if the mistake is not visible for two years. We register both warranty layers in writing, with durations stated, before we pull out of the driveway.
On the higher-end custom side, we have installed and serviced doors from CWS, ES Windows, and ECO Window Systems, as well as ViewLux units. CWS and ES Windows sell through select dealers, so when we quote one of those lines you see exactly what you are paying for, side by side on paper with a comparable Andersen or Pella. Whether your existing door is a PGT impact unit in Tradition or a Pella French door in Torino, we can service it and, when replacement makes more sense, quote you a door that fits the opening and the house.
Signs You Need Door Installation Right Now
- The door binds against the frame in summer. Wood and composite doors swell in Port St. Lucie humidity, but a door that consistently sticks in the same spot is telling you the frame has moved or the hinges have sagged. Forcing it will crack the jamb, and a cracked jamb means a full replacement instead of a hinge adjustment.
- Daylight shows around the closed door. If you can see light through the gap at the top or latch side, the weatherstripping is not compressing. That gap lets conditioned air out and humid air in, and it means the slab was hung out of square. A new door set true will show an even reveal on all three sides.
- You have to lift the door to lock it. Lifting the handle to get the deadbolt to throw means the hinges are worn or the frame has racked. This wears out the lock and the plates with it. A new pre-hung door with a reinforced strike plate fixes the root cause instead of buying you six more months.
- The threshold has gone soft or shows water stains. A spongy threshold means water has been working its way in, usually from sprinkler overspray against the door. Water at the threshold travels into the subfloor and the bottom of the jamb. The fix is a new sill pan, and usually a new door to go with it.
- You are re-staining or re-caulking the door every year. In the St. Lucie sun, a west-facing wood door will need maintenance regardless, but a door that peels and cracks every season has likely lost its finish and is taking on moisture. A fiberglass replacement with a factory finish will hold up in the Port St. Lucie climate for a decade or more.
Our Door Installation Process - Step by Step
- 1
Measure and inspect the opening. We measure the rough opening at top, middle, and bottom, and check the floor for level with a laser. If the rough opening is out of square by more than we can correct with shims, we tell you before any work starts, and we quote the fix as part of the job.
- 2
Quote manufacturers side by side on paper. You sit at your kitchen table and see the actual prices for the doors we recommend. We do not give a single round number. You get a written, line-item estimate with the door, hardware, labor, and any opening repair listed separately, so the number does not change after the first day.
- 3
Set the frame and hang the slab. We shim the frame at every hinge and behind the strike plate, then set the door so the reveal is even on all three sides. The door should swing freely and stop where you leave it. If the pane is not true, the job is not done, and we do not leave until it is.
- 4
Seal and flash the perimeter. We apply the flashing tape, sill pan, and perimeter caulking in the order the manufacturer specifies, not in whatever order is fastest. In Port St. Lucie, the rain comes sideways in the summer, and the difference between a dry threshold and a rotten subfloor is whether the flashing laps the right direction.
- 5
Register the warranties and clean up. Both manufacturer warranty layers get registered in writing, with durations stated, before the truck leaves. We walk the site with you, show you how the hardware works, and make sure the old door and all fasteners are gone from the property. The Done Right Promise applies from that moment.
How Much Does Door Installation Cost in Port St. Lucie?
A typical entry door replacement in Port St. Lucie runs $1,200 to $4,500 depending on the material, glass package, and whether the frame needs work. A set of double French doors generally lands between $2,800 and $7,000 installed, and a folding or pivot door system can run from $6,000 up to $15,000 or more for custom sizes and impact-rated glass. Storm doors are the most affordable install we do, usually $600 to $1,800 including the door and hardware.
What moves the price: the door material, whether the unit is impact-rated, whether the existing frame is salvageable, and the condition of the rough opening. A rotten jamb or an out-of-square rough opening adds labor, and you want a contractor who tells you that during the estimate, not after the demo. How to avoid overpaying: get the price in writing, line by line, and make sure the quote includes warranty registration. Our free estimates cover the door, the labor, the hardware, and any opening repair, all listed separately, so there are no surprise line items on the bill.
Door Installation Near Port St. Lucie - Our Service Area
TruePane installs doors throughout Port St. Lucie and the surrounding communities, including Door Installation in Indiantown and Door Installation in White City. We also work regularly in Fort Pierce, Jensen Beach, Palm City, Stuart, Sewall’s Point, Port Salerno, Hobe Sound, and Fort Pierce South. Most door installations in this area we can schedule within a week, and the work itself is completed in a single visit. When you call (772) 362-3326, you reach someone local who knows the difference between Tradition and Torino, and who can tell you when our next crew is in your neighborhood.
Serving Port St. Lucie, FL - Our Local Coverage Area
We’re based in the Port St. Lucie area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Door Installation in Port St. Lucie
Door installation is the process of setting a new door and frame into an existing opening, including leveling the frame, shimming it square, securing it to the framing, and sealing it against air and water. It covers the measurement, the removal of the old door when needed, and the installation of hinges, locks, and weatherstripping. In Port St. Lucie, proper installation also means flashing the sill and perimeter correctly for our rain and humidity. TruePane installs entry, French, bifold, pivot, storm, and custom doors, and we register both warranty layers in writing before we leave.
Most single entry door installations take one day from start to finish, including removal of the old door and cleanup. Double or French door systems may take a full day or a bit longer if we find framing damage that needs repair. Custom doors with special sizes or impact glass can take two to four weeks to order, and then one to two days on site. We will give you a written schedule with the estimate, and we will be there when we say.
Entry doors in Port St. Lucie typically run $1,200 to $4,500 installed, while French doors range from $2,800 to $7,000 and folding or pivot systems can exceed $10,000 for custom work. The material, impact rating, and condition of the rough opening drive most of the cost difference. Our estimates are free, written, and line-itemed, so you will know the exact number before any work begins. Call (772) 362-3326 for a quote on your specific door and opening.
Yes. We are an authorized installer for PGT, CGI, and ES Windows, and we service existing PGT doors throughout Port St. Lucie. For PGT impact doors, we follow the factory installation specs exactly, because an impact door installed incorrectly will not perform in a storm. If you have a PGT or Andersen door that is binding or leaking, we can assess whether it is a repairable issue or time for a new unit.
For a failed entry door or a door that will not lock, we do everything we can to get a technician out quickly, and a live person answers the phone 24 hours a day at (772) 362-3326. Stock entry and storm doors can often be installed within a few days. Custom sizes and impact-rated doors need lead time from the manufacturer, and we will tell you that timeline honestly up front rather than promising a date we cannot keep.
Every door we install carries two layers of warranty: the manufacturer’s warranty on the door and components, and our Done Right Promise on the workmanship. Under The Keystone Standard, we register both manufacturer warranty layers in writing and state the durations before the truck leaves your driveway. If something is not done right within 90 days, we make it right, with no paperwork fights and no fine print that covers neither.
Clear the area around the door on both sides, including any furniture, planters, or wall decor within about six feet, so our crew has room to lay out the new door and work safely. If you have pets, keep them in another part of the house during the install. We handle the removal and disposal of the old door, and we protect the floor from the door to the truck with drop cloths. You do not have to do anything to the opening before we arrive.
Schedule Your Door Installation in Port St. Lucie Today
When your door no longer closes true, it is not going to fix itself, and every month it goes unaddressed is another month of water and air moving through the gaps. Call (772) 362-3326 and a live person answers, 24/7. We will schedule a free, no-obligation estimate, measure the opening properly, and give you a written price before you commit to anything. In Port St. Lucie, you want a door company that will still answer the phone in ten years. That is us.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Port St. Lucie since 2008.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After